Firefly Phototherapy can be used in combination with following medical devices:

Firefly Phototherapy displays number 01:26 for the first 3 seconds after it's turned on. It means:

Firefly Phototherapy has 8 screws connecting the top and bottom base. While opening the device it’s best to leave one of the screws on the top to:

For measuring the 12V DC path the multimeter should be set to:

When all 4 LEDs are not working on the panel it means that at least one of them failed:

When unsoldering, LED panel should be separated from the heatsink because:

Colibri Phototherapy requires following tools for the assembly:

Colibri Phototherapy can be used in combination with following medical devices:

The optimal distance of Colibri Phototherapy canopies from the patient is:

Dolphin CPAP temperature sensor silicon port should be installed at:

Dolphin CPAP temperature sensors should be connected to the control box using:

To enter Dolphin CPAP's maintenance interface:

Dolphin CPAP's oxygen sensor should be replaced when the reading is:

To calibrate Dolphin CPAP's oxygen sensor:

Wallaby Warmer requires following tools for the assembly:

Wallaby Warmer side panels should be removed for cleaning because:

Wallaby Warmer requires 2 fuses:

When measuring the value at the Wallaby Warmer's terminal marked '220VAC':

When connecting the Wallaby Warmer's signal wires you should pay attention to:

Dolphin CPAP breathing circuit has 2 set of tubes: